tag:blogger.com,1999:blog-3667585771094877801.post4606777149007829671..comments2024-03-28T00:21:54.121-07:00Comments on InMoov: Arduino test with robot armAnonymoushttp://www.blogger.com/profile/06964775091618957956noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-3667585771094877801.post-5032640472846142212012-06-30T20:26:04.598-07:002012-06-30T20:26:04.598-07:00Thanks for the Arm cover changes, the new wrist an...Thanks for the Arm cover changes, the new wrist and the upgraded fingers. I'm done today - Saturday, June 30, 2012 - with the printing of all the V3 Left Hand/Forearm parts. And I was having so much fun with the printer printing well that I printed the wrist upgrade for my V1/2 Right Hand too. Plus, after watching your videos again I see what made my life more difficult. You smartly hard mount the control lines to the servos THEN string them up to the finger tips and tie off. I was doing it in reverse which made it more troublesome adjusting the proper tensions and getting access to the servo horns. The obvious, once you see, how to do it better. Thanks much!BAShttps://www.blogger.com/profile/11712266694307971483noreply@blogger.comtag:blogger.com,1999:blog-3667585771094877801.post-71600862777128577852012-06-03T14:57:59.065-07:002012-06-03T14:57:59.065-07:00Hi, Brian
Thanks for the comments, Too bad your ha...Hi, Brian<br />Thanks for the comments, Too bad your hand isn't fonctional yet, because it's fun once it starts to actuate. Anyway, I'm sure someday it will be ready. About your suggestion, you are totally right, it would be much easier to use the covers as "covers" and not as "servo brackets covers". Since I'm planning to re-model the robpart1 for to get a 180° degree wrist turn, I might get up to that update you suggest.<br />Cordially,<br />HairygaelAnonymoushttps://www.blogger.com/profile/06964775091618957956noreply@blogger.comtag:blogger.com,1999:blog-3667585771094877801.post-59962639097414028162012-06-01T19:17:03.598-07:002012-06-01T19:17:03.598-07:00Well, your obvious lack of ignorance is displaying...Well, your obvious lack of ignorance is displaying your intelligence. The project is real history and future making. I am happy to follow your project with the building of your copy here in Pittsburgh. <br /><br />I apologize for my lack in keeping up. I stopped to look at your blender files and got stumped by the blender software. I am also not connecting my fingers to the installed servos, yet. I'm reviewing revision ideas and new materials for the production prints. ;-)<br /><br />I'd like to suggest, for the hand, placing elevated servo supports on the lower forearm. This would move the two cover servos to the bottom forearm. This way the servos can be stationary for easier finger ligament installation, layout, tensioning, and maintenance. The cover would then, be - a cover.<br /><br />Compliment:<br />What a neat guy with a really neat idea and real results! <br /><br />Regards, Brian.BAShttps://www.blogger.com/profile/11712266694307971483noreply@blogger.com